TACHOGRAPH PROGRAMMER (TACHO)
Tachograph programmer (Tacho) is designed for verification, calibration and configuration of control devices (tachograph) when installed on vehicles. The device allows you to define the W figure determination on measuring track or rolling road, K figure measure, can be used as speed simulator for the tachograph when checking the speedometer and cluster calibration.
The Tachograph programmer calibrates and programs all analogue and digital tachographs
Supports IMS (Independent Motion Signal / Second speed signal) parameters on DTCO 2.0, SE5000 Exakt Duo and EFAS-4.
Supports 'VDO counter' parameter on DTCO 2.0
Supported Tachographs:
Analogs: KTCO 1314/1318, Motometer EGK100, FTCO 1319, MTCO 1324/1390, TSU 1391, VR2400.
Digitals: DTCO 1381 (DTCO® 2.1 active), SE5000 (Exakt Duo), SmarTach, EFAS-4.
A Workshop Card is required to calibrate the digital tachographs
Tachograph Programmer CD400 Functions:
Basically, a tachograph is a device that measures and records the speed and distance driven by a vehicle. The data are recorded in the form of graphics on a paper disk.
The new digital tachographs record those data on its embedded memory and also on the smartcard of the driver.
The Tachograph programmer CD400 calibrates and programs all analogue and digital tachographs.
Workshop card's PIN recording and input through CD400.
Clock test.
Sensor pairing (KITAS activation).
DTCS reading (Digital) and erasing.
Speed simulation and customizable automatic test diagram.
cluster calibration reset and adjustment (mileage correction).
Activation and deactivation of VDO counter.
Activation and deactivation of IMS (Independent Motion Signal).
Parameter programming.
K figure measure on KTCO 1314, KTCO 1318 and FTCO1319.
W figure determination on measuring track (with optional photo-cell) or rolling road.
Supported languages: English, German, Spanish, French,Dutch, Portuguese, Turkish, Romanian,Syriac, Russian